Modeling Different Types of Faucets in 3ds Max

One of the most common things that you will no doubt end up modeling is faucets. The reason for this is that you can basically find them in many different environments. You can find them in the kitchen, bathroom, garden so pretty much quite common item. Modeling faucets is not really that hard, but if you haven’t done it it can be challenging. For today’s post i actually chose to cover this topic with couple of videos.

Preparing The Blueprint For Real World Scale

Before we jump in directly in the modeling phase i wanted to take this chance and make an intro video. In this video i will show you how to take a blueprint, and set it up for Real World Scale. I wanted to start with this as i want to make sure everyone knows how to do it. It is a very basic thing to know, yet a lot of people struggle with it. So before we dive in on the matter of modeling Faucets check out this intro video. If you know how to do this, then keep reading as we are about to jump to the modeling part.

Modeling Of The Subi Faucet

In this video of modeling faucets we are going to tackle the Subi Faucet. In order to get the technical blueprint for this faucet i went over to the Phoenix site. As you can see in the video i took the line drawing, and basically made it into a blueprint. By watching this video you will see my approach to modeling something like this. You will notice that i like to logically separate the model before i commence with the actual modeling. By watching the video you will learn how to model this type of faucets. Another thing is how to control the edges, as well as how to deal the loss of volume. It was a fun video to make, so i hope it will be fun for you guys to watch.

Modeling A Bibb Faucet

In the last video for this post we look at a standard Bibb Faucet. This is a faucet that probably everyone has seen in their life. These faucets can be found pretty much anywhere, interiors and exteriors. So in the video below you will see how i approach modeling a model like this. But instead of explaining what i did, i would rather show you in the video.

Summary

So from this post you should come out with information on how to setup a blueprint. Another thing that you will learn is how to model two faucets, and based on those models create your own. As i said in the video, i had fun making these videos so i hope you have fun watching them. And like always i hope you managed to learn something new here today. So if this was the case then like, comment and share this post so it can reach more people.

Take care for now and i will see you all in the next post.

Bookmark the permalink.

Leave a Reply

Your email address will not be published.

  • 2015 © Copyright DKCGI | All rights reserved.